crmopk.blogg.se

How to use virtual audio cable with mini speech
How to use virtual audio cable with mini speech










Mini UHF (male) to SO239 (UHF/PL female) pigtail adapter with 30 cm RG58 coax.Two 6.3mm phono male to 3.5mm phono female adapters to connect a headset to the radio.Power cable 2.0m for connecting to power supply.LAN-cable 1.8m for connecting to local network.Specifications are subject to change without notice or obligation and specifications are only guaranteed within the amateur radio bands. SunSDR2 PRO Block Diagram SunSDR2 PRO Specifications RF ADC, bit MHz They will be supported in the future ExpertSDR2 software releases. * ** *** These functions are supported by the transceiver’s hardware, but are not implemented in the ExpertSDR2 software. Ethernet LAN interface provides a fast and reliable connection to PC.Internal power-meter for HF and VHF bands and SWR-meter for HF band.Antenna switch with 2 HF antenna connectors and separate VHF antenna connector (Mini UHF connectors).An opportunity to use the transceiver in SO2V mode.Input for external 10 MHz reference oscillator.

how to use virtual audio cable with mini speech

  • Monitoring delay in CW mode is about 5-6 ms.
  • An opportunity to use external filters in the middle of the RF path, using ADC IN and RX OUT (SMA connector).
  • how to use virtual audio cable with mini speech

  • An opportunity to use the transceiver as a signal generator via DAC OUT connector (SMA connector).
  • ALC connector for external power amplifiers*.
  • ExtCTRL connector to control external devices with 8 powerful keys with open collector.
  • Professional TX processing module provides the most advanced tuning capability for voice operation.
  • TCI interface for seamless connection with third-party software, the list of software with TCI support.
  • Microphone and E-Coder are connected to the remotely set up PC
  • A remote control operation, using it, you connect PTT and CW-key to the E-Coder panel.
  • 2 software RXs + SubRX for each of them ( 4 slices total) + independent wideband Bandscope up to 80 MHz.
  • Independent TX path based on DUC (Direct Up-Conversion) architecture.
  • Independent RX path based on DDC (Direct Down-Conversion) architecture.
  • Modern hardware along with the ExpertSDR software makes this high-performance SDR transceiver the perfect base station and at the same time perfectly suitable for field operations. The SunSDR2 PRO transceiver was designed for advanced operation on HF and VHF bands, even the most demanding operator will be surprised by its capabilities.












    How to use virtual audio cable with mini speech